2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

Brake Actuator 

BRAKE ACTUATOR - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Brake actuator xNo. 3 brake actuator bracket 93 95 82 in *lbf
Brake actuator x Brake actuator bracket 92 94 81 in *lbf
Brake actuator xNo. 4 brake actuator bracket 18 184 13
Brake actuator x Brake accumulator pump connector box 60 61 53 in *lbf
Brake tube flare nut 14 (15) 145 (155) 10 (11)
No 5 brake actuator bracket x Body 11 112 8
Brake actuator and brake accumulator pump assembly bolt 20 204 15
Brake actuator and brake accumulator pump assembly nut

Front Speed Sensor 

FRONT SPEED SENSOR - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Front speed sensor bolt 85 87 75 in *lbf
Skid control sensor wire clamp bolt

Rear speed sensor 

REAR SPEED SENSOR - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Rear speed sensor bolt 85 87 75 in *lbf
Skid control sensor wire clamp bolt
Skid control sensor wire clamp nut 55 56 49 in *lbf

Yaw Rate Sensor 

YAW RATE SENSOR - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Yaw rate sensor bolt 90 92 80 in *lbf

Skid Control ECU 

SKID CONTROL ECU - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Skid control ECU bracket bolt 85 87 75 in *lbf
Skid control ECU bracket nut
Skid control ECU bolt
Skid control ECU nut
Brake fluid reservoir bolt
No 1 motor cooling pipe x Skid control ECU bracket 13 133 10

Brake Control Power Supply 

BRAKE CONTROL POWER SUPPLY - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Brake control power supply assembly xNo. 1 brake control power supply bracket 85 87 75 in *lbf
Brake control power supply assembly x HV battery 80 82 71 in *lbf

Brake Pedal Stroke Sensor 

BRAKE PEDAL STROKE SENSOR - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Brake pedal stroke sensor bolt 85 87 75 in *lbf

(). For use without SST

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.