2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
AXLE - TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Front wheel set bolt 140 1428 103
Steering knuckle x Front disc brake caliper flexible hose 20 204 15
Steering knuckle x Front disc brake caliper 135 1377 100
Steering knuckle x FrontNo. 1 suspension upper arm assembly 60 612 44
Steering knuckle x FrontNo. 2 suspension upper arm assembly 60 612 44
Steering knuckle x Tie rod assembly 60 612 44
Steering knuckle x Front lower ball joint 113 1152 83
Steering knuckle x Front disc brake dust cover 80 82 71 in *lbf
Steering knuckle x Front axle hub sub-assembly 65 663 48
Steering knuckle x Speed sensor 85 87 75 in *lbf
Steering knuckle x Skid control sensor wire 85 87 75 in lbf
Front drive shaft assembly x Front axle shaft nut 294 3000 217
Rear wheel set bolt 140 1428 103
Rear axle carrier x Rear disc brake caliper assembly 86 877 63
Rear axle carrier x Rear shock absorber assembly 80 816 59
Rear axle carrier x Rear upperNo. 1 control arm assembly 160 1632 118
Rear axle carrier x Rear upperNo. 2 control arm assembly 160 1632 118
Rear axle carrier x Toe control link sub-assembly 118 1203 87
Rear axle carrier x RearNo. 1 suspension arm assembly 118 1203 87
Rear axle carrier x RearNo. 2 suspension arm assembly 225 2294 166
Rear axle carrier x Speed sensor rear 85 87 75 in *lbf
Rear axle carrier x Rear axle hub and bearing assembly 97 989 72
Rear axle carrier x Parking brake anchor block 76 775 56
Toe control link sub-assembly x Load sensing valve sensor bracket 53 54 47 in *lbf
Rear suspension member x RearNo. 2 suspension arm assembly 150 1530 111
Rear stabilizer link assembly x RearNo. 2 suspension arm assembly 26 265 19
Rear drive shaft x Rear axle shaft nut 290 2957 214
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.