2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
2UR-FSE INTAKE - TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Intake manifold x Cylinder head 21 214 15
Purge VSV x Intake manifold 21 214 15
Water by-pass pipe hose x Intake manifold 10 102 7
Engine motor cable clamp bracket x Intake manifold 10 102 7
Flexible hose bracket x Engine motor cable clamp bracket 80 82 71 in *lbf
Injector driver x Intake manifold 10 102 7
Engine wire harness protector x Intake manifold 10 102 7
Engine wire harness bracket x Engine 10 102 7
Engine wire harness's ground cable x Engine and body panel for timing chain cover 10 102 7
for engine room RH side 85 87 75 in *lbf
Air cleaner case LH and RH x Cylinder head cover 50 51 44 in *lbf
Intake air control valve actuator x Intake manifold 21 214 15
Intake air control valve actuator x Actuator rod 54 55 48 in *lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.