Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the windshield deicer system.
- *: Use the Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- INSPECT BATTERY VOLTAGEÂ
Standard voltage:Â
11 to 14 VÂ
If the voltage is below 11 V, recharge or replace the battery before proceeding.
- INSPECT ELECTRIC POWER CONTROL SYSTEM*Â
- Using the Techstream, check the electric power control system's load control history (see OPERATION CHECK ).
- INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*Â
- Use the Techstream to check that the CAN communication system is functioning normally.
ResultÂ
RESULT REFERENCE CHARTResult Proceed to CAN DTC is not output A CAN DTC is output B B: Go to CAN COMMUNICATION SYSTEMÂ (see HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to Next StepÂ
- Use the Techstream to check that the CAN communication system is functioning normally.
- PROBLEM SYMPTOMS TABLEÂ
- Refer to the PROBLEM SYMPTOMS TABLEÂ
.
ResultÂ
RESULT REFERENCE CHARTResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B: Go to step  7
A: Go to Next StepÂ
- Refer to the PROBLEM SYMPTOMS TABLEÂ
.
- OVERALL ANALYSIS AND TROUBLESHOOTING*Â
- Terminals of ECU (see TERMINALS OF ECUÂ )
- DATA LIST/ACTIVE TEST (see DATA LIST/ACTIVE TESTÂ )
- Inspection
- REPAIR OR REPLACEÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
