Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Lexus LS 460 AWDFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle (Aa80F): TCM: Installation
- INSTALL TCM
- Install the TCM with the 2 nuts.
Torque: 5.5 N*m (56 kgf*cm, 48 in.*lbf)
- Connect the 4 connectors.
- Install the TCM with the 2 nuts.
- INSTALL ENGINE ROOM ECU COVER
- Install the engine room ECU cover with the 3 bolts.
Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf)
- Install the engine room ECU cover with the 3 bolts.
- INSTALL ENGINE ROOM SIDE COVER LH
- INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY
- Install the air cleaner inlet cover with the 2 clips.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- INSTALL COWL TOP VENTILATOR LOUVER (See INSTALLATION )
- CHECK AUTOMATIC TRANSMISSION SYSTEM PRECAUTION
- After replacing the TCM, certain procedures are necessary (See AUTOMATIC TRANSMISSION SYSTEM ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
