2009 Lexus LS 460 AWDFACTORY OEM SERVICE PROCEDURE

Shift Lock System: Inspection

  1. INSPECT SHIFT LOCK SOLENOID 
    1. Measure the resistance according to the value(s) in the table below.

      HINT:

      Disconnect the solenoid connector.

      Standard Resistance 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      3 (SLS-) - 4 (SLS+) Always 104 to 126 Ω

      If the result is not as specified, replace the transmission floor shift assembly.

      Fig 1: Identifying Shift Lock Solenoid Connector Terminal
      G04948524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

    HINT:

    Disconnect the solenoid connector.

    Standard Resistance 

    RESISTANCE REFERENCE

    Tester Connection Switch Condition Specified Condition
    1 (P+) - 2 (P-) Parking position switch pushed 10 kΩ or higher
    1 (P+) - 2 (P-) Parking position switch released Below 1 Ω

    If the result is not as specified, replace the transmission floor shift assembly.

    Fig 2: Identifying Shift Lock Solenoid Connector Terminal
    G04948525Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.