Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Lexus LS 460 AWDFACTORY OEM SERVICE PROCEDURE
On-Vehicle Inspection
- CHECK INTAKE AIR CONTROL FUNCTION
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the tester ON.
- Enter the following menus: Powertrain/Engine/Active Test/Activate the VSV for Intake Control.
- When power is supplied, check that the actuator rod operates.
- INSPECT AIR CLEANER FILTER ELEMENT
- Check that the air cleaner filter elements are not excessively dirty.
If the air cleaner filter elements are excessively dirty, replace both of them at the same time.
- Check that the air cleaner filter elements are not excessively dirty.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
