Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
Automatic Light Control Operation
The automatic light control system works when the light control switch is turned to AUTO. The automatic light control sensor detects the brightness around the vehicle. The system then automatically turns the taillights and headlights on if the brightness is below the set level and turns the taillights and headlights off when the surroundings become brighter than the set level.
Light Auto Turn Off Operation
* When lights other than the headlights are lit and the light control switch is in the 'Tail' or 'AUTO' position, the taillights and front fog lights will be turned off if the engine switch is changed from on (IG) to off, and the driver side door is opened.
* When the headlights are lit and the light control switch is in the 'Head' or 'AUTO' position, the engine switch has been changed from on (IG) to off, and the light off delay timer (30 seconds) has expired since all the doors were opened and then closed or if all the doors are locked, then operating the wireless door lock will turn off the headlights, taillights and front fog lights.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
