2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

FRONT SEAT 

FRONT SEAT - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Front seatback spring assembly at Front seat adjuster assembly 43.0 439 32
Front seat cushion spring assembly at Front seat adjuster assembly 21.0 214 15
Front seat inner belt assembly at Front seat adjuster assembly 42.0 428 31
Reclining remote control lever sub-assembly at Front seatback spring assembly 8.0 82 71 in.*lbf
Front seat assembly at Body 37.0 377 27

REAR SEAT 

REAR SEAT - TORQUE SPECIFICATIONS

Part tightened N*m kgf*cm ft.*lbf
Wind deflector board assembly at Rear seat headrest assembly 5.0 51 43 in.*lbf
Rear seat headrest assembly at Body 5.0 51 43 in.*lbf
Rear seatback assembly at Body 18.0 184 13
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.