Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
3UZ-FE FUEL - TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
|---|---|---|---|---|
| V-bank cover at engine | 5.0 | 51 | 44 in.*lbf | |
| Intake air connector pipe at engine | 5.0 | 51 | 44 in.*lbf | |
| No. 1 air cleaner inlet at engine | 5.0 | 51 | 44 in.*lbf | |
| Fuel pressure pulsation damper assembly at Fuel delivery pipe sub-assembly | with SST | 33 | 337 | 24 |
| without SST | 39 | 397 | 29 | |
| Fuel delivery pipe sub-assembly at Intake manifold | 21 | 214 | 15 | |
| Purge VSV at Intake manifold | 18 | 184 | 13 | |
| No. 1 V-bank cover bracket at Intake manifold | 7.5 | 76 | 66 in.*lbf | |
| No. 2 V-bank cover bracket at Intake manifold | 7.5 | 76 | 66 in.*lbf | |
| No. 3 V-bank cover bracket at Intake manifold | 7.5 | 76 | 66 in.*lbf | |
| No. 4 V-bank cover bracket at Intake manifold | 7.5 | 76 | 66 in.*lbf | |
| Fuel tank vent tube set plate at Fuel tank | 6.0 | 61 | 52 in.*lbf | |
| Fuel pump resistor at Body | 8.0 | 82 | 71 in.*lbf | |
| Fuel sender gauge at Fuel tank | 1.5 | 15 | 13 in.*lbf | |
| Fuel tank band at Body | 39.2 | 400 | 29 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
