Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
System Normal Condition Check
WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SYSTEM NORMAL CONDITION
- If the symptom is applicable to any of the following, it is intended behavior, and not a malfunction.PROBLEM SYMPTOM CHART
Symptom Answer A longer route than expected is chosen. Depending on road conditions, navigation ECU may determine that a longer route is quicker. Even when distance priority is high, shortest route is not shown. Some paths may not be advised due to safety concerns. When vehicle is put into motion immediately after engine starts, navigation system deviates from actual position. If the vehicle is moved before the navigation system activates, system may not react. When running on certain types of roads, especially new roads, vehicle position deviates from actual position. When vehicle is driving on new roads not available on map disc, system attempts to match it to another nearby road, causing position mark to deviate. - The following symptoms are not a malfunction, but are caused by errors inherent in the GPS, gyro sensor, speed sensor, and navigation ECU.
- The current position mark may be displayed on a nearby parallel road.
- Immediately after a fork in the road, the current vehicle position mark may be displayed on the wrong road.
- When the vehicle turns right or left at an intersection, the current vehicle position mark may be displayed on a nearby parallel road.
- When the vehicle is carried, such as on a ferry, and the vehicle itself is not running, the current vehicle position mark may be displayed in the position where the vehicle was until a measurement can be performed by the GPS.
- When the vehicle runs on a steep hill, the current vehicle position mark may deviate from the correct position.
- When the vehicle makes a continuous turn of 360, 720, 1,080, etc. degrees, the current vehicle position mark may deviate from the correct position.
- When the vehicle moves erratically, such as constant lane changes, the current vehicle position mark may deviate from the correct position.
- When the turn the ignition switch ACC or OFF position on a turn table before parking, the current vehicle position mark may not point in the correct direction. The same will occur when the vehicle comes out of parking.
- When the vehicle is running on a snowy road, on a mountain path with the chains installed, or with a spare tire, the current vehicle position mark may deviate from the correct position.
- When a tire is changed, the current vehicle position mark may deviate from the correct position.
HINT:
- The diameter of the tire may change, causing a speed sensor error.
- Performing the tire change in calibration mode will allow the system to correct the current vehicle position faster.
- If the symptom is applicable to any of the following, it is intended behavior, and not a malfunction.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
