2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Navigation Ecu: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

  1. INSTALL NO. 2 DISC PLAYER BRACKET 
    1. Install the bracket with the 2 screws.
      Fig 1: Locating No. 2 Disc Player Bracket Screws
      G05293371Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL DISC PLAYER BRACKET 
    1. Install the bracket with the 2 screws.
      Fig 2: Locating Disc Player Bracket Screws
      G05293372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NAVIGATION ECU 
    1. Connect the 3 connector.
    2. Install the ECU with the bolt and 2 nuts.
      Fig 3: Locating Navigation ECU Connectors
      G05293373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL LUGGAGE COMPARTMENT TRAY BRACKET FRONT 
    1. Install the 2 bracket with the 2 bolts and 2 nuts.
  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT (See  INSTALLATION  ) 
  6. INSTALL TONNEAU COVER ASSEMBLY (See  INSTALLATION  ) 
  7. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY REAR (See  INSTALLATION  ) 
  8. INSTALL TOOL BOX COVER (See  INSTALLATION  ) 
  9. INSTALL SPARE WHEEL COVER ASSEMBLY 
  10. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH (See  INSTALLATION  ) 
  11. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH (See  INSTALLATION  ) 
  12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT 
  13. INSTALL REAR FLOOR FINISH PLATE (See  INSTALLATION  ) 
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  15. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.