Back Window Frame: Removal

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. HALF OPEN ROOF PANEL 
   1. Half open the roof panel (see MANUAL OPEN OPERATION  ).
      Fig 1: Opening Roof Panel

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. REMOVE ROOF SIDE GARNISH INNER RH 
   1. Using a clip remover, remove the clip labeled A.
      Fig 2: Identifying Clip Labeled A

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using a screwdriver, detach the 7 clips.

      HINT:

      Tape the screwdriver tip before use.

   3. Remove the side garnish.
3. REMOVE ROOF SIDE GARNISH INNER LH 

   HINT:

   Use the same procedures described for the RH side.

4. REMOVE REAR ROOF HEADLINING ASSEMBLY 
   1. Using a screwdriver, detach the 7 clips.

      HINT:

      Tape the screwdriver tip before use.

   2. Remove the roof headlining.
      Fig 3: Identifying Roof Headlining

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. REMOVE BACK WINDOW FRAME SUB-ASSEMBLY UPPER 
   1. Using a T40 "TORX" socket, remove the 8 screws.
   2. Remove the back window frame.
      Fig 4: Identifying Back Window Frame And Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REMOVE REAR REMOVABLE ROOF WEATHERSTRIP 
   1. Remove the 4 screws, 2 nuts and 4 clips.
   2. Using a clip remover, detach the clips.
   3. Remove the removable roof weatherstrip rear.
      Fig 5: Identifying Screws, Nuts And Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. REMOVE ROOF SIDE RAIL WEATHERSTRIP RETAINER RH 
   1. Remove the 4 screws and weatherstrip retainer.
      Fig 6: Identifying Screws And Weatherstrip Retainer

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. REMOVE ROOF SIDE RAIL WEATHERSTRIP RETAINER LH 

   HINT:

   Use the same procedures described for the RH side.

9. REMOVE BACK WINDOW OUTSIDE MOLDING (See  REMOVAL  ) 
10. REMOVE BACK WINDOW GLASS (See  REMOVAL  )