Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
MULTI-DISPLAY (w/ Navigation System): Installation
WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL MULTI-DISPLAY (CENTER DISPLAY)
- Install the multi-display.
- Connect the 4 connectors and install the clamp.
- Install the harness clamp with the 2 screws.
- Install the 2 screws.
- Install the No. 2 retainer with the 5 screws.
- Install the No. 1 retainer with the 6 screws.
- Install the instrument panel finish upper panel with the 4 screws to the both sides.
- INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
- Connect the connector and detach the clip.
- Install the panel with the 2 bolts and 2 screws.
- INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (See INSTALLATION )
- INSTALL INSTRUMENT PANEL SAFETY PAD GARNISH SUB-ASSEMBLY (See INSTALLATION )
- INSTALL AIR CONDITIONING CONTROL ASSEMBLY (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see
INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see
INITIALIZATION
).
- CHECK SRS WARNING LIGHT (See INSTALLATION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
