Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Back Window Glass: Installation
HINT:
A bolt without a torque specification is shown in the standard bolt chart.
- INSTALL BACK WINDOW GLASS ADHESIVE DAM
- Apply primer G to the installation part of the glass adhesive dam.NOTE:
- Allow the primer G to dry for 3 minutes or more.
- Throw away any leftover Primer G.
- Do not apply too much Primer G.
- Remove the peeling paper from the adhesive part of the dam. Install the dam (adhesive side) to the glass (Primer G area) as shown in the illustration.
Standard measurement
AREA MEASUREMENT SPECIFIED CONDITIONArea Measurement a 0.7 mm (0.028 in.)
- Apply primer G to the installation part of the glass adhesive dam.
- INSTALL BACK WINDOW OUTSIDE MOULDING
- Using a brush or sponge, apply Primer G to the glass where the moulding will be installed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.