Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK MILÂ
- Check that the MIL lights up when turning the ignition switch ON.
OK:Â
MIL lights upÂ
OK: SYSTEM OKÂ
NG: Go to next stepÂ
- CHECK CONNECTION BETWEEN TECHSTREAM AND ECMÂ
- Connect the Techstream to the DLC3.
- Turn the ignition switch ON and tester ON.
- Check the communication between the Techstream and ECM.
ResultÂ
RESULT CHARTCondition Proceed to Communication is not possible A Communication is possible B B:Â GO TO MIL CIRCUITÂ
A: Go to next stepÂ
- CHECK ECM (VC VOLTAGE)Â
- Turn the ignition switch ON.
- Measure the voltage of the ECM connector.
Result:Â
Voltage is not 5 VÂ
- CHECK MIL (THROTTLE POSITION SENSOR)Â
- Disconnect the T26 throttle body connector.
- Turn the ignition switch ON.
- Check the MIL.
ResultÂ
RESULT CHARTCondition Proceed to MIL does not illuminate A MIL Illuminates B B: REPLACE THROTTLE BODY ASSEMBLYÂ
A: Go to next stepÂ
- CHECK MIL (CANISTER PUMP MODULE)Â
- Disconnect the C12 canister pump module connector.
- Turn the ignition switch ON.
- Check the MIL.
ResultÂ
RESULT CHARTCondition Proceed to MIL does not Illuminate A MIL Illuminates B B: REPLACE CANISTERÂ
A: Go to next stepÂ
- CHECK WIRE HARNESS (ECM - BODY GROUND)Â
- Disconnect the T26 throttle body connector.
- Disconnect the C12 canister pump module connector.
- Disconnect the E2 ECM connector.
- Measure the resistance of the wire harness connector.
Standard resistanceÂ
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Specified Condition E2-29 (VC) - Body ground 10 kΩ or higher NG: REPAIR OR REPLACE HARNESS AND CONNECTORÂ
OK: REPLACE ECMÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
