Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Position Sensor: Installation
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
- Install the crankshaft position sensor with the bolt.
Torque: 8.0 N*m (80 kgf*cm, 71 in.*lbf)
- Connect the crankshaft position sensor connector.
- INSTALL FRONT FENDER APRON SEAL RH
- Install the front fender apron seal RH with the clip and 2 bolts.
- INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
- Install the front fender splash shield sub-assembly RH with the screw.
- INSTALL ENGINE UNDER COVER NO.1 (See INSTALLATION )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.