Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus RX 350 FWDFACTORY OEM SERVICE PROCEDURE
Power Window Control System: Fail-Safe
- CHECK POWER WINDOW FAIL-SAFE FUNCTION
HINT:
If there is a malfunction in the power window system, some of the power window functions will be disabled.
Driver side power window
DRIVER SIDE POWER WINDOWMalfunctioning Part Disabled Function Operative Function Pulse sensor circuit in power window motor - AUTO UP/DOWN function
- Power window operation function after ignition off
- Manual UP (fully pulled UP position)
- Manual DOWN
- Remote (AUTO and manual)
- Remote function after ignition OFF (AUTO and manual)
- MANUAL UP/DOWN function via driver side door lock key cylinder
- MANUAL DOWN function via transmitter
CPU in power window master switch - AUTO UP/DOWN function
- Remote function (AUTO and manual)
- MANUAL UP/DOWN function via driver side door lock key cylinder
- MANUAL DOWN function via transmitter
- Manual UP (fully pulled UP position)
- Manual DOWN
Power windows except driver side power window
POWER WINDOWS EXCEPT DRIVER SIDE POWER WINDOWMalfunctioning Part Disabled Function Operative Function - Pulse sensor circuit in power window motor
- CPU in power window master switch
- Communication between master switch and each power window switch
- AUTO UP/DOWN function
- Power window operation function after ignition OFF
- MANUAL UP/DOWN function via driver side door lock key cylinder
- MANUAL DOWN function via transmitter
- Manual UP (fully pulled UP position)
- Manual DOWN
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
