2008 Lexus RX 350 FWDFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. INSPECT POWER WINDOW REGULATOR MOTOR 
    1. Remove the power window motor.
      Fig 1: Identifying Power Window Regulator Motor
      G05006578Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Apply battery voltage to the motor connector according to the table below.
      NOTE: Do not apply battery to any terminals except terminals 1 and 2.

      Standard 

      VOLTAGE SPECIFICATION TABLE

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 1 (D)
      Battery negative (-) → Terminal 2 (U)
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 2 (U)
      Battery negative (-) → Terminal 1 (D)
      Motor gear rotates counterclockwise

    NG: REPLACE POWER WINDOW REGULATOR MOTOR 

    OK: Go to next step. 

  2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK MASTER SWITCH) 
    1. Disconnect the P22 and P23 connectors.
      Fig 2: Identifying Window Regulator Motor & Multiplex Network Master Switch Connector Terminal
      G05274255Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      STANDARD VOLTAGE SPECIFICATION TABLE

      Tester Connection Condition Specified Condition
      P22-1 (UP) - P23-2 (U) Always Below 1 Ω
      P22-11 (DN) - P23-1 (D) Always Below 1 Ω
      P22-1 (UP) - Body ground Always 10 kΩ or higher
      P22-11 (DN) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.