Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus RX 350 AWDFACTORY OEM SERVICE PROCEDURE
Engine Control System - DTC P0560 - P2A03
- DTC P0560 System Voltage
- DTC P0604 Internal Control Module Random Access Memory (RAM) Error
- DTC P0606 ECM / PCM Processor
- DTC P0607 Control Module Performance
- DTC P0617 Starter Relay Circuit High
- DTC P0630 VIN not Programmed or Mismatch - ECM / PCM
- DTC P0657 Actuator Supply Voltage Circuit / Open
- DTC P0705 Transmission Range Sensor Circuit Malfunction (PRNDL Input)
- DTC P2102 Throttle Actuator Control Motor Circuit Low; DTC P2103 Throttle Actuator Control Motor Circuit High
- DTC P2111 Throttle Actuator Control System - Stuck Open; DTC P2112 Throttle Actuator Control System - Stuck Closed
- DTC P2118 Throttle Actuator Control Motor Current Range / Performance
- DTC P2119 Throttle Actuator Control Throttle Body Range / Performance
- DTC P2120 Throttle / Pedal Position Sensor / Switch "D" Circuit; DTC P2122 Throttle / Pedal Position Sensor / Switch "D" Circuit Low Input; DTC P2123 Throttle / Pedal Position Sensor / Switch "D" Circuit High Input; DTC P2125 Throttle / Pedal Position Sensor / Switch "E" Circuit; DTC P2127 Throttle / Pedal Position Sensor / Switch "E" Circuit Low Input; DTC P2128 Throttle / Pedal Position Sensor / Switch "E" Circuit High Input; DTC P2138 Throttle / Pedal Position Sensor / Switch "D" / "E" Voltage Correlation
- DTC P2121 Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance
- DTC P2195 Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1); DTC P2196 Oxygen (A/F) Sensor Signal Stuck Rich (Bank 1 Sensor 1); DTC P2197 Oxygen (A/F) Sensor Signal Stuck Lean (Bank 2 Sensor 1); DTC P2198 Oxygen (A/F) Sensor Signal Stuck Rich (Bank 2 Sensor 1)
- DTC P2238 Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 1 Sensor 1); DTC P2239 Oxygen (A/F) Sensor Pumping Current Circuit High (Bank 1 Sensor 1); DTC P2241 Oxygen (A/F) Sensor Pumping Current Circuit Low (Bank 2 Sensor 1); DTC P2242 Oxygen(A/F) Sensor Pumping Current Circuit High (Bank 2 Sensor 1); DTC P2252 Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 1 Sensor 1); DTC P2253 Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 1 Sensor 1); DTC P2255 Oxygen (A/F) Sensor Reference Ground Circuit Low (Bank 2 Sensor 1); DTC P2256 Oxygen (A/F) Sensor Reference Ground Circuit High (Bank 2 Sensor 1)
- DTC P2420 Evaporative Emission System Switching Valve Control Circuit High
- DTC P2610 ECM / PCM Internal Engine Off Timer Performance
- DTC P2A00 A/F Sensor Circuit Slow Response (Bank 1 Sensor 1); DTC P2A03 A/F Sensor Circuit Slow Response (Bank 2 Sensor 1)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
