Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus RX 350 AWDFACTORY OEM SERVICE PROCEDURE
VSC Off Switch: Installation
- INSTALL VSC OFF SWITCH
- Engage the 2 claws and install the VSC off switch.
- INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
- INSTALL COWL SIDE TRIM SUB-ASSEMBLY (See INSTALLATION )
- INSTALL FRONT DOOR SCUFF PLATE
HINT:
Use the same procedures described for the RH side.
(See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- INSPECT ABS WARNING LIGHT AND VSC WARNING LIGHT
HINT:
(See TEST MODE PROCEDURE )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.