2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE

Pattern Select Switch: Removal

  1. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH  (See REMOVAL )
  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE PARKING BRAKE HOLE COVER  (See REMOVAL )
  4. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE POSITION INDICATOR HOUSING ASSEMBLY 
    1. Disconnect the 2 connectors.
    2. Detach the 7 claws and remove the position indicator housing.
    Fig 1: Removing Position Indicator Housing Assembly
    G05760719Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE NO. 1 PATTERN SELECT SWITCH ASSEMBLY 
    1. Disconnect the connector.
    2. Using a small screwdriver, detach the 2 claws and remove the pattern select switch from the position indicator housing.
    Fig 2: Removing Pattern Select Switch From Position Indicator Housing
    G05760702Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.