Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE
Engine Coolant Temperature Sensor: Removal
- REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
- REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
- REMOVE UPPER RADIATOR SUPPORT SEAL (See REMOVAL )
- REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (See REMOVAL )
- REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See REMOVAL )
- REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See REMOVAL )
- DRAIN ENGINE COOLANT (See REPLACEMENT )
- REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
- REMOVE ENGINE COOLANT TEMPERATURE SENSOR
- Disconnect the sensor connector.
- Using a 19 mm deep socket wrench, remove the sensor.
- Remove the gasket from the sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.