2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE

Yaw Rate And Deceleration Sensor: Installation

  1. INSTALL YAW RATE SENSOR 
    1. Connect the sensor connector and then attach the clamp to the hole of the sensor bracket.
      NOTE: Securely connect the connector.
    2. Install the yaw rate sensor with the 2 bolts.

      Torque: 15 N*m (148 kgf*cm, 11 ft.*lbf) 

    NOTE:
    • Make sure that the sensor is oriented correctly.
    • If the sensor is dropped, replace it.
    • When installing the sensor, make sure to avoid impacts to the sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.