Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)Â
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and turn the Techstream on.
- Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
ABS/VSC/TRACÂ
ACTIVE TEST DETAILTester Display Test Part Control Range Diagnostic Note Buzzer Skid control buzzer Buzzer ON/OFF The buzzer can be heard. - Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the Techstream.
ResultÂ
RESULT REFERENCEResult Proceed to Buzzer sounds/stops. A Buzzer does not sound or sounds constantly. B A: USE SIMULATION METHOD TO CHECKÂ (See HOW TO PROCEED WITH TROUBLESHOOTING )
B: Go to next stepÂ
- INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)Â
- Disconnect the E5 skid control buzzer connector.
- Measure the voltage according to the value(s) in the table below.
Standard VoltageÂ
VOLTAGE SPECIFICATIONTester Connection Switch Condition Specified Condition E5-2 - Body ground Engine switch on (IG) 11 to 14 V NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
OK: Go to next stepÂ
- INSPECT SKID CONTROL BUZZERÂ
- Apply battery voltage to the skid control buzzer, and check that the buzzer sounds.
OKÂ
MEASUREMENT CONDITION AND SPECIFIED CONDITIONMeasurement Condition Specified Condition - Battery positive (+) voltage - Terminal 2
- Battery negative (-) voltage - Terminal 1
Buzzer sounds Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NG: REPLACE SKID CONTROL BUZZER ASSEMBLYÂ (See REMOVALÂ )
OK: Go to next stepÂ
- CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)Â
- Disconnect the A24 skid control ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard ResistanceÂ
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition A24-30 (BZ) - ES-1 Always Below 1 Ω A24-30 (BZ) - Body ground Always 10 kΩ or higher NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
OK: REPLACE MASTER CYLINDER SOLENOIDÂ (See DISASSEMBLY )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
