2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE

Skid Control Buzzer: Inspection

  1. INSPECT SKID CONTROL BUZZER ASSEMBLY 
    1. Apply battery voltage to the skid control buzzer and check that the buzzer sounds.
    Fig 1: Applying Battery Voltage To Skid Control Buzzer
    G05629935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK 

    MEASUREMENT CONDITION AND SPECIFIED CONDITION

    Measurement Condition Specified Condition
    Battery positive (+) voltage → Terminal 2 Battery negative (-) voltage → Terminal 1 Skid control buzzer sounds

    If the result is not as specified, replace the skid control buzzer assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.