Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE
On-Vehicle Inspection
- CHECK BRK LP RELAY
- Remove the BRK LP relay from the engine room relay block.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
RESISTANCE SPECIFICATIONTester Connection Condition Specified Condition 3-4 Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω 3-5 Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher If the result is not as specified, replace the relay.
- Install the BRK LP relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.