Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE

Rear Power Window Switch: Installation

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
1. Attach the 2 claws to install the regulator switch.
INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
1. Connect the connector.
2. Attach the 6 claws to install the armrest base panel.
  
  Fig 2: Identifying Armrest Base Panel Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.