2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE

Power Window Master Switch: Removal

  1. REMOVE FRONT UPPER ARMREST BASE PANEL LH 
    1. Using a molding remover, detach the 5 claws.
    2. Disconnect the connector and remove the armrest base panel.
      Fig 1: Identifying Molding And Claws
      G05767459Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY 
    1. Remove the 3 screws and master switch.
      Fig 2: Identifying Master Switch Screws
      G05767460Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.