Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus LX 570FACTORY OEM SERVICE PROCEDURE
Charging System: Generator: Installation
- INSTALL GENERATOR ASSEMBLY
- Install the generator with the 3 bolts and nut.
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
- Connect the generator connector.
- Connect the generator wire with the nut.
Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
- Install the terminal cap.
- Install the harness bracket to the generator with the bolt.
Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf)
- Install the generator with the 3 bolts and nut.
- CONNECT OIL COOLER PIPE ASSEMBLY (See INSTALLATION )
- CONNECT VANE PUMP ASSEMBLY (See INSTALLATION )
- INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
- INSTALL AIR CLEANER HOSE ASSEMBLY (See INSTALLATION )
- INSTALL FRONT FENDER APRON SEAL FRONT RH (See INSTALLATION )
- INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
- INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
- INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See INSTALLATION )
- INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
- INSTALL UPPER RADIATOR SUPPORT SEAL (See INSTALLATION )
- INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
- INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
