Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
Fuel Pump: Installation
- INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (See INSTALLATION )
- INSTALL FUEL TANK VENT TUBE SET PLATE (See INSTALLATION )
- INSTALL REAR FLOOR NO. 2 SERVICE HOLE COVER (See INSTALLATION )
- INSTALL REAR NO. 2 SEAT ADJUSTER ASSEMBLY (for Power Seat) (See INSTALLATION )
- INSTALL REAR NO. 2 SEAT ADJUSTER ASSEMBLY (for Ottoman) (See INSTALLATION )
- INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) (See INSTALLATION )
- INSTALL SERVICE PLUG GRIP (See INSPECTION )
- INSTALL BATTERY SERVICE HOLE COVER (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
- INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )
- INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.