2008 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Knock Sensor: Removal

HINT:

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

  1. REMOVE INTAKE MANIFOLD 
    1. Remove the intake manifold (See REMOVAL ).
  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY LH  (See REMOVAL )
  5. REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE SEPARATOR CASE 
    1. Disconnect the fuel pressure sensor connector.
      Fig 1: Identifying Fuel Pressure Sensor Connector
      G04943089Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and separator case.
      Fig 2: Locating Separator Case And Bolts
      G04943090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE KNOCK SENSOR 
    1. Disconnect the 4 sensor connectors.
    2. Remove the 4 bolts and 4 sensors.
      Fig 3: Locating Knock Sensor Connector And Bolts
      G04943091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.