2008 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Engine Coolant Temperature Sensor: Removal

  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH  (See REMOVAL )
  5. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH  (See REMOVAL )
  6. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  7. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
    2. Fig 1: Locating Engine Coolant Temperature Sensor
      G04943082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the sensor.
    4. Remove the gasket from the sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.