Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
Related DTCS
OPERATION DESCRIPTION CHART
| DTC No. | Monitoring Item |
|---|---|
| P043E | Reference orifice low flow (built into canister pump module) |
| P043F | Reference orifice high flow (built into canister pump module) |
| P0441 |
|
| P1420 | Small leak from canister |
| P1421 | Gross leak from canister |
| P1422 | Small leak from fuel tank |
| P1423 | Gross leak from fuel tank |
| P2401 | Leak detection pump OFF stuck (built into canister pump module) |
| P2402 | Leak detection pump ON stuck (built into canister pump module) |
| P2419 | Vent valve ON (close) stuck (built into canister pump module) |
| P2420 | Vent valve OFF (vent) stuck (built into canister pump module) |
| P2450 | Fuel vapor-containment valve open stuck |
| P2451 | Fuel vapor-containment valve close stuck |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.