Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the push-button start function.
- * Use the intelligent tester or Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- INSPECT BATTERY VOLTAGEÂ
Standard voltage:Â
11 to 14 VÂ
If the voltage is below 11 V, recharge or replace the battery before proceeding
- INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*Â
- Using the intelligent tester or Techstream, check if the CAN communication system is functioning normally (see
DIAGNOSIS SYSTEM
).
ResultÂ
RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B: Go to CAN COMMUNICATION SYSTEMÂ , (see DIAGNOSTIC TROUBLE CODE CHART ).
A: Go to next StepÂ
- Using the intelligent tester or Techstream, check if the CAN communication system is functioning normally (see
DIAGNOSIS SYSTEM
).
- CHECK FOR DTC*Â
- Check for DTCs and note any stored DTCs (see DTC CHECK / CLEARÂ )
- Delete the DTCs.
- Check whether the same DTC(s) relevant to the hybrid control system or smart access system with push-button start recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above
ResultÂ
RESULT REFERENCEResult Proceed to DTC output does not reoccur A Hybrid control system DTC output reoccurs B Smart access system with push-button start DTC output reoccurs C
B: Go to HYBRID CONTROL SYSTEMÂ , (see DIAGNOSTIC TROUBLE CODE CHART )
C:Â Go to STEP Â 7
A: Go to next StepÂ
- PROBLEM SYMPTOMS TABLEÂ
ResultÂ
RESULT REFERENCEResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B:Â Go to STEP Â 7
A: Go to next StepÂ
- OVERALL ANALYSIS AND TROUBLESHOOTING*Â
- TERMINALS OF ECU (see TERMINALS OF ECUÂ )
- DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TESTÂ )
- ADJUST, REPAIR OR REPLACEÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
