2008 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Skid Control Buzzer: Inspection

  1. INSPECT SKID CONTROL BUZZER ASSEMBLY 
    1. Apply battery voltage to the skid control buzzer, and check that the buzzer sounds.
      Fig 1: Applying Battery Voltage To Skid Control Buzzer Assembly
      G04949792Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK 

      BATTERY VOLTAGE SPECIFICATION

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 2 Skid control buzzer sounds
      Battery negative (-) → Terminal 1

      If the result is not as specified, replace the skid control buzzer assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.