Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK LIN COMMUNICATION SYSTEM
- Check for LIN communication system DTCs related to the power window control system.
Result:
RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B B: GO TO LIN COMMUNICATION SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to Next Step
- CHECK POWER WINDOW OPERATION FUNCTION AFTER POWER SWITCH OFF
- Check the power window operation function after the power switch is turned OFF.
Result:
RESULT REFERENCEResult Proceed to Driver side door or front passenger side door is opened within 45 seconds but power window can still operate A 45 seconds pass and the power windows can still operate B B: REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
A: Go to Next Step
- READ VALUE USING INTELLIGENT TESTER OR TECHSTREAM (DOOR COURTESY SWITCH)
- Use the Data List to check if the main body ECU is functioning properly
- Intelligent tester
MAIN BODY:
DATA LIST - MAIN BODYTester Display Measurement Item/Range Normal Condition D DOR CTY SW Driver side door courtesy switch signal / ON or OFF ON Driver door open
OFF Driver door closedP DOR CTY SW Front passenger side door courtesy switch signal / ON or OFF ON Front passenger door open
OFF Front passenger door closed - Techstream
Main body:
DATA LIST - MAIN BODYTester Display Measurement Item/Range Normal Condition D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON Driver door open
OFF Driver door closedP Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON Front passenger door open
OFF Front passenger door closed - Intelligent tester
OK: Tester display changes normally when door courtesy switch is operated.
NG: Go to step 4
OK: REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
- Use the Data List to check if the main body ECU is functioning properly
- CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
- Open the driver side door and check that the map light illuminates.
OK: Map light illuminates.
- Open the front passenger side door and check that the map light illuminates.
OK: Map light illuminates.
NG: REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (See FRONT DOOR COURTESY SWITCH )
OK: REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)
- Open the driver side door and check that the map light illuminates.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
