HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
1. Install the floor shift with the 4 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 74 in.*lbf)
2. Connect the 5 wire harness clamps to the floor shift.
3. Connect the 2 connectors.
  
  Fig 1: Locating Wire Harness Clamps Of Floor Shift
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Temporarily connect the shifting rod to the connecting rod swivel with the nut.
  HINT:
  
  The nut will be tightened to a torque specification during the shift lever position adjustment procedure.
  
  Fig 2: Locating Floor Shift Gear Shifting Rod
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 CONSOLE BOX DUCT
1. Install the duct with the 2 screws.
INSTALL CONSOLE BOX ASSEMBLY
1. Install the console box (see INSTALLATION ).
ADJUST SHIFT LEVER POSITION
1. Adjust the shift lever position (see ADJUSTMENT ).
INSPECT SHIFT LEVER POSITION
1. Inspect the shift lever position (see REMOVAL ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL COWL TOP VENTILATOR LOUVER (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Floor Shift Assembly: Installation