Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Check the ECUs connected to the CAN bus (see DIAGNOSIS SYSTEM ).

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   No malfunction appears	A
   Malfunction appears	B

B: GO TO CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Check for DTCs.

   Result 

   RESULT REFERENCE
   
   

   Condition	Proceed to
   DTC is not output	A
   CAN system DTC is output	B
   LIN system DTC Is output	C

B: GO TO CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

C: GO TO LIN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body / Combination Meter / Active Test.
5. Check the condition of the pattern select indicator light by operating the Techstream.

   Combination Meter 

   CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp ECT PWR	Pattern select indicator light (PWR)	ON or OFF	-
   Indicat. Lamp ECT SNOW	Pattern select indicator light (SNOW)	ON or OFF	-

   OK: Indicator light turns on or off according to the Techstream operation. 

NG: GO TO METER / GAUGE SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body / Center Console Switch / Data List.
5. Read the value displayed on the Techstream.

   Center Console Switch 

   NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ECT Power Mode Switch	Pattern select switch (PWR) status/ ON or OFF	Pattern select switch (PWR) is: ON: Pushed OFF: Not pushed	-
   ECT Snow Mode Switch	Pattern select switch (SNOW) status/ ON or OFF	When turning engine switch on (IG): OFF ↓ Pattern select switch (ECT SNOW) is pushed: ON ↓ Pattern select switch (ECT SNOW) is pushed again: OFF	-

   OK: On the Techstream screen, item changes between ON and OFF according to switch operation. 

NG: REPLACE NO. 1 CONSOLE SWITCH 

OK: Go to next step 

1. Replace the TCM (see REMOVAL  ).

NEXT: PERFORM A/T CODE REGISTRATION  (See REGISTRATION  )