2008 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) 
    1. Check for DTCs in the skid control ECU (see DTC CHECK / CLEAR ).

      Result 

      RESULT CHART

      Result Proceed to
      DTC is not output OK
      DTC is output NG

    NG: REPAIR CIRCUIT INDICATED BY DTC OUTPUT 

    OK: Go to next step 

  2. CHECK DTC (CAN COMMUNICATION SYSTEM) 
    1. Check for DTCs in the CAN communication system (see DIAGNOSIS SYSTEM ).

      Result 

      RESULT CHART

      Result Proceed to
      DTC is not output A
      DTC is output B

    B: REPAIR CIRCUIT INDICATED BY DTC OUTPUT 

    A: REPLACE STEERING CONTROL ECU  (See REMOVAL  )

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.