How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the steering lock system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard Voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. CHECK DTC* 
   1. Check for DTC (See DTC CHECK / CLEAR  ).

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is output	A
      DTC is not output	B

   A: Go to step  6

   B: Go to next step 

4. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  6

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU (See TERMINALS OF ECU  ).
   2. DATA LIST / ACTIVE TEST (See DATA LIST / ACTIVE TEST  ).
6. REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END