2008 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Diagnosis System

  1. DESCRIPTION 
    1. When troubleshooting a vehicle with a diagnosis system, connect the Techstream to the DLC3 of the vehicle and read various data output from the steering lock ECU.

      The steering lock ECU records DTCs when the ECU detects a malfunction in itself or in its circuits.

    2. The diagnosis information of the steering lock ECU is transmitted to the Techstream via the certification ECU as the steering lock ECU is not connected to the CAN communication system.
    3. The steering lock ECU does not store DTCs regarding past problems.

      HINT:

      When the engine switch is off, the main body ECU to which the Techstream is to be connected may be malfunctioning or in sleep mode.

      Communication with the Techstream is impossible if the main body ECU is not working.

    4. As the steering lock ECU's memory data will be deleted, do not remove the fuses or disconnect the battery terminals until the DTCs are checked and noted.
    5. Malfunctions related to systems other than the steering lock ECU's system may cause DTCs to be output. Note any DTCs related to other systems.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.