2008 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

Other Systems: Clock: Installation

  1. INSTALL CLOCK ASSEMBLY 
    1. Attach the 2 claws to install the clock.
      2. Fig 1: Identifying Clock Assembly Claws
      G04945887Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY WITH BRACKET (w/o Multi-display)  (See INSTALLATION )
  3. INSTALL DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET (w/ Multi-display)  (See INSTALLATION )
  4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET  (See INSTALLATION )
  5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER  (See INSTALLATION )
  6. INSTALL REAR CONSOLE PANEL UPPER  (See INSTALLATION )
  7. INSTALL NO. 3 BOX PANEL  (See INSTALLATION )
  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
  13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.