2008 Lexus LS 460LFACTORY OEM SERVICE PROCEDURE

How To Proceed With Troubleshooting

HINT:

  • Use the following procedures to troubleshoot the front power seat control system.
  • *: Use the Techstream.
  1. VEHICLE BROUGHT TO WORKSHOP 
  2. INSPECT BATTERY VOLTAGE 

    Standard Voltage: 

    11 to 14 V 

    If the voltage is below 11V, recharge or replace the battery before proceeding.

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
    1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result 

      DTC OUTPUT RESULT

      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

    B: Go to CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

    A: Go to Next Step 

  4. CHECK FOR DTC* 
    1. Check for DTCs (see DTC CHECK / CLEAR  )
    2. Clear the DTCs (see DTC CHECK / CLEAR  )
    3. Recheck for DTCs (see DTC CHECK / CLEAR  )

      Result 

      DTC OUTPUT RESULT

      Result Proceed to
      DTC does not reoccur A
      DTC reoccurs B

    B: Go to step  7

    A: Go to Next Step 

  5. PROBLEM SYMPTOMS TABLE 

    Result 

    RESULT CHART

    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms B

    B: Go to step  7

    A: Go to Next Step 

  6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
    1. Data List / Active Test (see DATA LIST / ACTIVE TEST  )
    2. Terminals of ECU (see TERMINALS OF ECU  )
    3. Operation Check (see OPERATION CHECK  )
  7. ADJUST, REPAIR OR REPLACE 
  8. CONFIRMATION TEST 

    NEXT: END 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.