NOTE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

SYSTEM NAME REFERENCE

System Name	See Procedure
Power Window Control System	INITIALIZATION

NOTE:

If any parts are replaced, perform the following as necessary referring to the table below.

COMPONENTS REFERENCE

Replaced Part		Reset Memory*1	Set Transmission Compensation Code	Learning by Driving (Road Test)
Automatic transmission assembly		-*2	Perform*3	Perform
Valve body assembly Shift solenoid valve SL1, 2, 3, 4 and 5		-	-	Perform
TCM (If possible, read the transmission compensation code from the previous TCM)	Possible	-	Perform*4	Perform
	Impossible	-	Perform*5	Perform
Engine assembly ECM		Perform	-	Perform
HINT 1 Reset Memory cannot be completed by only disconnecting and reconnecting the cable to the negative (-) battery terminal 2 When "Set Transmission Compensation Code" is performed, "Reset Memory" is automatically completed 3 Set the compensation code for the new automatic transmission 4. Read the compensation code from the previous TCM, then transfer it to the new TCM *5 Set the transmission compensation code of the current automatic transmission Registration of the transmission compensation code (See REGISTRATION ). Learning by driving (Road Test) (See INITIALIZATION ) Reset Memory (See INITIALIZATION )

NOTE: Reset Memory cannot be completed by only disconnecting and reconnecting the cable to the negative (-) battery terminal.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Automatic Transmission System: Precaution