Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE
DTC Check/Clear
- CHECK FOR DTCS
- Turn the engine switch off.
- Connect the Techstream to the DLC3
- Turn the engine switch on (IG)
- Turn the Techstream on
- Read the DTCs following the display on the Techstream Enter the following menus Chassis / EMPS / Trouble Codes
- Refer to the Diagnostic Trouble Code Chart for DTC information (See DIAGNOSTIC TROUBLE CODE CHART )
- CLEAR DTCS
- Turn the engine switch off
- Connect the Techstream to the DLC3
- Turn the engine switch on (IG)
- Turn the Techstream on
- Clear the DTCs by following the display on the Techstream Enter the following menus Chassis / EMPS / Trouble Codes
- According to the display on the Techstream, select the trouble code data display with the clear button
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.