Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Service Data
Cold tire inflation pressure
| Tire Size | Cold tire inflation pressure kPa (kgf/cm2 , psi) | ||
|---|---|---|---|
| Front | Rear | Front | Rear |
| 225/40R19 93Y | 255/35R19 96Y | 250 (2.5, 36) | 250 (2.5, 36) |
When driving under the above vehicle conditions at sustained high speeds of above 160 km/h (100 mph), in countries where such speeds are permitted by law, inflate the front and rear tires to 310 kPa (3.1 kgf/cm2 , 45 psi) provided that it does not exceed the maximum cold tire inflation pressure molded on the tire sidewall
| Maximum tire runout | 1.0 mm (0.0394 in) |
| Maximum wheel imbalance after adjustment | 80 g (0.01761b) |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.