Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE
Torque Specifications
FRONT SUSPENSION - TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Front shock absorber with coil spring x Body | 67 | 683 | 49 |
| Front shock absorber nut x Piston rod | 28 | 286 | 21 |
| Front shock absorber with coil spring x Front lower suspension arm | 157 | 1601 | 116 |
| Front upper suspension arm x Steering knuckle | 87 | 887 | 64 |
| Steering knuckle x Front lower ball joint assembly | 120 | 1223 | 89 |
| Steering knuckle x Front disc brake cylinder | 78 | 795 | 58 |
| Front shock absorber with coil spring x Front speed sensor | 60 | 61 | 53 in *lbf |
| Front upper suspension arm x Body | 49 | 500 | 36 |
| Front lower suspension arm x Front lower ball joint | 162 | 1651 | 119 |
| Front lower suspension arm x Front suspension member | 135 | 1377 | 100 |
| Front lower suspension arm x No. 2 lower arm bracket assembly | 113 | 1152 | 83 |
| Front lower suspension arm with No. 2 lower arm bracket assembly x body | Bolt 1.204 Bolt 2 x nut 86 Bolt 3.50 | Bolt 1.2080 Bolt 2 x nut 877 Bolt 3.510 | Bolt 1.150 Bolt 2 x nut 63 Bolt 3 37 |
| Front lower ball joint x Tie rod assembly | 65 | 663 | 48 |
| Front No. 1 stabilizer bracket x body | 49 | 500 | 36 |
| Front No. 1 stabilizer bracket x Front No. 2 stabilizer bracket | 49 | 500 | 36 |
| Front stabilizer bar x Front stabilizer link assembly | 84 | 857 | 62 |
| Front stabilizer link assembly x Front lower suspension arm | 84 | 857 | 62 |
| Front height control sensor link assembly x Front stabilizer bar | 54 | 55 | 48 in *lbf |
| Front suspension member x power steering link assembly | 118 | 1203 | 87 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
