Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Occupant Classification System: Precaution: Precaution
When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.
| System Name | Refer to Procedure |
|---|---|
| Power Window Control System | Refer to INITIALIZATION |
| Sliding Roof System |
- INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENTÂ
- Perform the zero point calibration and sensitivity check if any of the following conditions occur.
- The occupant classification ECU is replaced.
- Accessories (seatback tray and seat cover, etc.) are installed.
- The front passenger seat is removed from the vehicle.
- The passenger airbag ON/OFF indicator ("OFF") comes on when the front passenger seat is not occupied.
- The vehicle is brought to the workshop for repair due to an accident or a collision.
NOTE:When an accident vehicle is brought into the workshop for repair, check the flatness of the body side that is equipped with the passenger seat. If the flatness is not within +- 3.0 mm (0.118 in.), adjust it to the specified range.
- Perform the zero point calibration and sensitivity check if any of the following conditions occur.
- EXPRESSIONS OF IGNITION SWITCHÂ
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this article.
Switch Type Ignition Switch (position) Engine Switch (condition) Expression Ignition Switch off LOCK Off Ignition Switch on (IG) ON On (IG) Ignition Switch on(ACC) ACC On (ACC) Engine Start START Start
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.