2008 Lexus IS FFACTORY OEM SERVICE PROCEDURE

Camshaft Oil Control Valve: Removal

  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL  )
  3. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH 
    1. Disconnect the camshaft timing oil control valve connector.
    2. Remove the bolt and the camshaft timing oil control valve assembly
      Fig 1: Locating Camshaft Timing Oil Control Valve Connector With Bolt
      G05751859Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 0-ring from the camshaft timing oil control valve assembly
      Fig 2: Locating O-Ring From Camshaft Timing Oil Control Valve Assembly
      G05751860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH 
    1. Disconnect the camshaft timing oil control valve connector.
    2. Remove the bolt and the camshaft timing oil control valve assembly.
      Fig 3: Locating Camshaft Timing Oil Control Valve Connector And Bolt
      G05751861Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 0-ring from the camshaft timing oil control valve assembly
      Fig 4: Locating O-Ring From Camshaft Timing Oil Control Valve Assembly
      G05751860Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.